Product Manual

1. Insert the Echo Module into rackmount enclosure (Figure 10).
2 Using the three thumbscrews you removed previously, secure the Echo Module
to the enclosure; do not overighten the screws (Figure 10).
3. Connect the included (or comparable) Thunderbolt 3 (40Gbps) cable, or any
Thunderbolt 4 cable, between the Thunderbolt port on the Echo Module and a
Thunderbolt port on the back of your computer (Figure 11). Secure the retainer
clip to the module if you attached it.
Section 6 – Echo Module Installation Steps
12
Figure 11
Support Note: Sonnet’s ThunderLok™ 3 Thunderbolt connector retainer clip
secures the included Thunderbolt 3 cable to the module to prevent
accidental disconnects. This clip is compatible with Sonnet 0.5- and 0.7-meter
Thunderbolt 3 cables.
To attach the clip to the cable, remove both items from their packaging, and then
insert the connector into the connector clip as shown (Figure 11). Note that the
connector will pass all the way through the clip; when you connect the cable to the
module, the clip will secure the connector.
Figure 10