Manual

Appendix

B – BNC Cable Installation

1. Insert the BNC cables through the BNC connector mounting holes, and

then secure them as shown. (Figure A3).

2. Return to step 14 on page 7, and complete the setup procedure.

C – Fan Switch Setting Information

The xMac mini Server includes a fan speed switch (Figure A4) which

enables you to change when the main fans’ speed increases relative to the

temperature inside the enclosure. Regardless the switch setting, the fans’

starting speed is the same. Note that this switch does not affect the power

supply’s fan operation.

• In High Speed Mode (factory setting), the fans’ speed begins to increase

when the temperature inside the enclosure exceeds 25˚ C (77˚ F), and

reaches full speed at 40˚ C (104˚ F). This setting is appropriate for all

compatible PCIe cards and is the default setting.

• In Low Speed Mode, the fans’ speed begins to increase when the

temperature inside the enclosure exceeds 35˚ C (95˚ F), and will speed

up somewhat as the temperature climbs toward 40˚ C (104˚ F). If you are

using PCIe cards that each require less than 15W of power, then you may

use this setting.

Figure A3

Figure A4