Product Manual

3. Insert the devices into the spaces beneath the computers, placing them
far enough back so that the devices’s cables may be routed through the
cover plates (Figure 7).
4. Connect the devices to the computers (Figure 7). If you are installing a
second module, do so now.
5. Using the previously removed screws, secure the cover plates to the
enclosure (Figure 8).
6. If you haven’t yet installed the RackMac Studio into its rack or case, do
so now.
7. Connect interface and power cables between devices and computers
as necessary; your installation is complete.
Accessory Installation Steps
Figure 7
Figure 8
6
Support Note: If you removed the cover plates to install devices in
the accessory spaces beneath the computers, it is important to reinstall
them in order to prevent the Mac Studios from drawing in warm air through
the openings.