Product Manual

4
Under-Desk/Under-Shelf Installation Steps
7. Insert the included magnetic Phillips screwdriver bit into your
drill.
8. Insert the screwdriver bit through the bottom of the bracket
and then balance an included 3/4-inch wood screw on its
tip (Figure 4).
9. Line up the screw holes in the top of the bracket
with the pilot holes you drilled, and then screw
in the screw sitting on the tip of the screwdriver
bit (Figure 4). Tighten the screw enough to hold the
bracket in place but leave it loose enough to move the
bracket to align the other screw holes
10. Install the three remaining 3/4-inch wood screws, and then
tighten all four screws so the bracket is held firmly; do not
overtighten the screws (Figure 4).
11. Remove your Mac Studio computer from its packaging, and
then carefully insert it into the bracket as shown. Push the
computer in until it stops (Figure 5).
12. Insert the locking bar through the bottom slots in the bracket
as shown (Figure 6).
Figure 4
Figure 5
Support Note: Installing the locking bar in the top slots
blocks many ventilation holes in the Mac Studio and may
impact your computer’s performance.
front of desk
Figure 6