Product Manual

8
Wall Mounting Installation Steps
Figure 14
Figure 13
9. Insert the included magnetic Phillips screwdriver bit into your
drill.
10. Insert the screwdriver bit through the bottom of the bracket
and then balance an included 1-1/2 inch wood screw on its
tip (Figure 13).
11. Line up the screw holes in the bracket with the pilot holes
you drilled into the wall, and then screw in the screw sitting
on the tip of the screwdriver bit (Figure 13). Tighten the
screw enough to hold the bracket in place but leave it loose
enough to move the bracket to align the other screw holes.
12. Install the three remaining 1-1/2 inch wood screws, and
then tighten all four screws so the bracket is held firmly; do
not overtighten the screws (Figure 13).
13. Remove your Mac Studio computer from its packaging.
Being sure to support the computer, carefully insert it into
the bracket with the top of the computer facing the wall; do
not drop the computer into the bracket (Figure 14).