Manual

4
Chapter 3 – PCIe Card Installation Steps
Figure 1
1. Remove the Echo Express SE I chassis from its packaging, and then set it
upside-down on a soft, flat, level surface.
2. Remove and set aside the four screws securing the feet to the bottom
of the outer case (Figure 1). Set aside the screws and feet.
3. Turn the Echo Express SE I chassis right-side-up
(Figure 2).
4. Place your hand on top of the outer case.
Remove the inner assembly by gently
grasping its faceplate by the edges and
pulling (Figure 2). Set aside the outer
case.
5. Remove and set aside the screw used to secure a PCIe card from
the Echo Express SE I chassis’ inner assembly (Figure 3). If you are
installing a double-width card, or an additional daughter card, remove
and set aside the screw securing the port access cover, and then
remove and set aside the cover.
Support Note: To avoid damaging components due to
static electricity discharge, wear an antistatic wrist strap
while working inside Echo Express SE I.
Figure 2
Figure 3
Inner
Assembly
Outer
Case