User Manual

4
Chapter 3 – PCIe Card Installation Steps
Figure 1
1. Remove the Echo Express SE I - Thunderbolt 3 Edition (T3E) chassis
from its packaging, and then set it upside-down on a soft, flat, level
surface.
2. Remove and set aside the four screws securing the feet to the
bottom of the outer case (Figure 1). Set aside the screws
and feet.
3. Turn the Echo Express SE I T3E chassis right-side up (Figure 2).
4. Place one hand on top of the outer case. Remove the
inner assembly by gently grasping its faceplate
by the edges and pulling (Figure 2). Set
aside the outer case.
5. Remove and set aside the screw used to secure a PCIe card from the
Echo Express SE I T3E chassis’ inner assembly (Figure 3). If you are
installing a double-width card, or an additional daughter card, remove
and set aside the screw securing the port access cover, and then
remove and set aside the cover.
Support Note: To avoid damaging components due
to static electricity discharge, wear an antistatic wrist
strap while working inside Echo Express SE I T3E.
Figure 2
Figure 3
Inner
Assembly
Outer
Case