Owner's manual

vii
Appendix A - CLI ASCII-Based Interface
• Date
Sets/displays the current date. The date range is 01/01/2000 to
12/31/2099.
set Date [MM]/[DD]/[YYYY]
get Date
• DeleteAllMaps (Immediate, Disabled on Error)
Removes all mapped devices from the map table. Upon the
subsequent POST, the default maps are loaded if no maps are
present.
DeleteAllMaps
SaveConfiguration command required
• DisplayEventLog (Immediate, Disabled on Error)
Displays the EventLog. The event log may be filtered using the
DisplayEventLogFilter command. The optional parameter n is
the number of lines to be displayed as a single page with no
user interaction. After the command has executed, use +, - or =
to scroll through the log. Type quit and press Return (Enter) to
exit the command.
DisplayEventLog <n>
• DisplayEventLogFilter (Immediate, Disabled on Error)
Filters the display of data for specified subsystems and levels
during DisplayEventLog mode. Valid event log subsystem
entries are platform-dependent. For set commands, the final
parameter indicates whether or not events from the specified
subsystem and level are displayed.
Default: all all all
set DisplayEventLogFilter [subsystem | all]
[level | all] [all | none]
get DisplayEventLogFilter [subsystem |all]
[level | all]
• DriveTest (Immediate, Disabled on Error)
Starts or stops a drive test with the previously specified
configuration. Drives being tested are not available for RAID
configuration or RAID operations. Only one test can be run at
a time.
DriveTest [Begin | Cancel]
• DriveTestClearList
Configures the next drive test to perform one of the
following operations: initialize (destructive write-only), read
(nondestructive read-only), verify (destructive verify), or init-
verify (destructive write-read-verify). The test is not started until
the DriveTest Begin command is given.
set DriveTestConfig [init | read | verify |
init-verify]
get DriveTestConfig
• DriveTestConfig (Disabled on Error)
Configures the next drive test to perform one of the
following operations: initialize (destructive write-only), read
(nondestructive read-only), verify (destructive verify), or init-
verify (destructive write-read-verify). The test is not started until
the DriveTest Begin command is given.
set DriveTestConfig [init | read | verify |
init-verify]
get DriveTestConfig
• DriveTestList (Disabled on Error)
Specifies drives to be run in the next drive test. This command
can be called with different eligible block IDs and each one is
added to the list. Drives which are not part of a RAID group or
are not hot spares are eligible. The all parameter automatically
chooses eligible drives. The test is not started until the DriveTest
Begin command is given..
set DriveTestList [drive [BlockDevID] | all]
get DriveTestList
• DriveTestStatus
Displays the status of the currently running drive test but
does not display performance metrics. If a block device ID is
not running or cannot be found, its state is idle and percent
complete is 0.
get DriveTestStatus <drive [BlockDevID]>
• DumpConfiguration (Immediate)
Displays the unit’s configuration to the Advanced page of the
Sonnet Web Management Tool or a terminal emulation or
Telnet session. The record may not be displayed completely in
the Sonnet Web Management Tool page.
DumpConfiguration
• DumpEventLog (Immediate)
Displays the contents of the EventLog to the Advanced page of
the Sonnet Web Management Tool or a terminal emulation or
Telnet session. The record may not be displayed completely in
the Sonnet Web Management Tool page.
DumpEventLog
• EmailFromAddress
Configures the Email address that the unit uses to communicate
with the Email server. Full Email address is a fully qualified
Internet Email address, not more than 128 characters long.
set EmailFromAddress [full email address]
get EmailFromAddress