Configuration Tool and Utilities Operation Manual Instruction Manual

iii
CLI Summary
The following chart summarizes the Command Line Interface
commands, their defaults, and an example of how to enter the
commands. Please note that commands which have no default
values have a blank entry in that column of the table.
WARNING: Do not use the CLI unless you are directed
to by a Sonnet technician, as changing parameters may
cause loss of data and/or disruption to performance and
reliability of the Fusion storage system.
Command Default Example
AutoMap automap
AutoMapOnBoot enabled set automaponboot enabled
AutoResume rebuild = enabled, erase = disabled, initialize
= enabled
set autoresume erase enabled raidgroup1
BlockDevClean blockdevclean 30
BlockDevIdentify blockdevidentify 30
BlockDevIDStop blockdevidstop
BlockDevInfo blockdevinfo 30
BlockDevScan blockdevscan
ClearEventLog cleareventlog
Date set date 03/03/2009
DeleteScheduledTasks deletescheduledtasks
DisplayScheduledTasks displayscheduledtasks
DriveAssureReport driveassurereport raidgroup1
DriveHealth disabled set drivehealth enabled
DriveHealthDisplay drivehealthdisplay all
DriveHealthStatus drivehealthstatus
DriveTest drivetest begin
DriveTestClearList drivetestclearlist all
DriveTestConfig not initiated set drivetestconfig read
DriveTestList get drivetestlist all
DriveTestStatus get driveteststatus
DumpConfiguration dumpconfiguration
DumpEventLog dumpeventlog
EventLog enabled set eventlog disabled
EventLogFilter all all all set eventlogfilter gen info all
Help help eventlog
HSAdd hsadd 3
Appendix A - CLI ASCII-Based Interface