Owner manual

Cannot Connect to Access Point

If you cannot make a connection to an Access Point, it could be due to one of the following

reasons:

• Physical connection problems at the Access Point. Check the AP and verify all the

connectors are plugged or screwed in securely.

• Incorrect network name (SSID). Make sure the SSID used is the same for both the

Aria extreme and the Access Point.

• Security settings different. Make sure the security settings are the same for both the

Aria extreme and the Access Point.

• Operation mode not configured properly. Make sure the Aria extreme is configured

to allow Infrastructure connections.

• Make sure you are not trying to connect to an 802.11a Access Point. 802.11a and

802.11b/g standards are not interoperable.

• The Access Point has reached its maximum number of supported clients.

• MAC address access control is enabled on the Access Point. If this is the case,

make sure your Aria extreme card’s MAC address is on the “Allow Access” list.