Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
7 of 26
Wall Mount System
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
1XB02WL00x 1XB02WL01x
Applies to Components:
Wall Flush Mount Support:
1. Install the Mounting Bracket to the wall with Anchor (if applicable) and Screw, align set screw holes with the direction of
Power Bar, then attach the Support onto the Mounting Bracket and tighten the two Set Screws with the Allen Key (Fig. 1).
2. Remove Flat Head Screw and Support Cap and align Power Bar with Support (Fig. 2).
3. Insert Power Bar into Support. Reattach Support Cap with Flat Head Screw (Fig. 3). Note: Wall Mount Support
(1XB02WL00x) is to be used in conjunction with Wall Mount Standard Power Feed (1XA08WL01x) or Remote (1XA08WL02x).
Fig. 1
Fig. 2
Fig. 3
Anchor
Mounting Bracket
Flat Head
Screw
Support
Cap
Screw
Apply to Wall Flush
Mount Offset Support
Support
Support
Power Bar
Allen Key
Set Screw
Fig. 1
Fig. 4
Anchor
Wall Flush Mount
Standard Power Feed
Wall Flush Mount
Support
Wall Flush Mount
Oset Support
Mounting Bracket
Screw
Support
Allen Key
Set Screw
Wall Mount Perpendicular Power Bar Hanger:
1. Install the Mounting Bracket to the wall with Anchor (if applicable) and Screw, align set screw holes
with the direction of Power Bar, then attach the Support onto the Mounting Bracket and tighten the
two Set Screws with the Allen Key (Fig. 1).
2. Insert Power Bars into Support. Note: Wall Mount Perpendicular Power Bar Hanger (1XB03WP00x) is to be used in
conjunction with Wall Flush Mount Support (1XB02WL00x), Wall Flush Mount Oset Support (1XB02WL01x) (Fig 4), and Wall
Flush Mount Standard Power Feed (1XA08WL01x) or Remote (1XA08WL02x) (Fig 4).
Applies to Components:
1XB03WP00x
Fig. 2
Fig. 3