Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
6 of 26
In-Line Ceiling Hanger Assembly:
1. Install the Mounting Bracket to the ceiling with Anchor (if applicable) and Screw, then screw the Post onto the Mounting
Bracket (Fig. 1).
2. For Hanger with Stem: Hand screw the Stem onto the Ceiling Hanger (Fig. 2).
3. Attaching the Ceiling Hanger Rod/Cable into the Post:
a. For Rod Hangers: Cut the Rod to the desired length, then insert the Rod into the Post and tighten the Set Screw with the
Allen Key (Fig. 3).
b. For Cord Hanger: Insert Cable into Post, then adjust to the desired length: to shorten, push the Cable up; to lengthen,
push in the Plunger while pulling down on the cable, release the Plunger to lock. Cut o the excess cable where it exits
the Post (Fig. 3).
4. Press down rmly on the top of the Power Bar, while pressing up on the bottom of the Hanger, until the Power Bar clicks
into place. Repeat for adjacent power bar (Fig. 2).
Ceiling Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Applies to Components:
1XB02IB06x
1XB02IB20x
1XB02IB06x-ST
1XB02IB20x-ST
1XB02IR18x
Fig. 1
Anchor
For RodFor Cable
Mounting
Bracket
Screw
Post
Or
Or
Set Screw
Allen Key
Fig. 2
Ceiling
Hanger
Rod
Ceiling
Hanger
Cable
Power Bar
Hanger
For Cable
For Stem
For Rod
Stem
Or
Or
Fig. 3
Or
For RodFor Cable
Rod
Cable
Plunger