Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
5 of 26
Ceiling Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Ceiling Hanger Assembly:
1. Install the Mounting Bracket to the ceiling with Anchor (if appropriate) and Screw, then screw the Post onto the Mounting
Bracket (Fig. 1).
2. Pass the Ceiling Hanger Rod/Cable through the Power Bar, then through the center hole of the Cover, making sure the
countersunk holes on the Cover are facing up. Attach the Cover to the Hanger using the two small Phillips Screws (Fig. 2).
3. For Hanger with Stem: Hand screw the Stem onto the Ceiling Hanger. (Fig. 2)
4. Attaching the Ceiling Hanger Rod/Cable into the Post:
a. For Rod Hangers: Cut the Rod to the desired length, then insert the Rod into the Post and tighten the Set Screw with the
Allen Key (Fig. 3).
b. For Cable Hanger: Insert Cable into Post, then adjust to the desired length: to shorten, push the Cable up; to lengthen,
push in the Plunger while pulling down on the cable, release the Plunger to lock. Cut o the excess cable where it exits
the Post (Fig. 2).
Fig. 1
Fig. 2
Fig. 3
Anchor
For Rod
For Rod
For Cable
For Cable
Mounting
Bracket
Power Bar
Hanger
Cover
Screw
Post
For Cable
For Stem
For Rod
Phillips
Screw
Stem
Or
Or
Or
Or
Or
Or
Or
Set Screw
Rod
Cable
Plunger
Allen Key
Ceiling
Hanger
Cable
Ceiling
Hanger
Rod
1XB02SB06x
1XB02SB20x
1XB02SB06x-ST
1XB02SB20x-ST
1XB02RB06x
1XB02RB20x
1XB02SR18x
Applies to Component: