Installation Sheet

June 10, 2019

4 of 26

Power Feed Hangers

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

In-Line Power Tap Hanger:

1. Install Double Cord Power Feed Hanger to Lower Power Bar and connect to the Power Feed by inserting the exposed

wires into the Power Feed Bushings. Secure by tightening the Set Screws with the included Allen Key (Fig. 1).

2. Install the Upper Power Bar between the two cords of the Double Cord Power Feed Hanger using appropriate hangers.

3. Remove Cord Caps from Tap Hanger by sliding them up and o the sides of the Tap Hanger (Fig. 2).

4. Position Tap Hanger under Upper Power Bar at junction with Double Cord Power Feed Hanger (Fig. 3). Press down rmly

on top of the Upper Power Bar, while pressing up on the bottom of Tap Hanger, until Tap Hanger clicks into place (Fig. 4).

5. Press each cord into the slot on each side of the Tap Hanger (Fig. 5).

6. To secure cord electrical connection, align Cord Cap over slot on each side of the Tap Hanger, and position the notches on

bottom of the Cord Cap to face toward Tap Hanger (Fig. 6), then rmly slide down into position (Fig. 6). Repeat on opposite

side.

Fig. 2

Fig. 6

Fig. 1

Fig. 4

Fig. 5

Fig. 3

Upper

Power Bar

Lower

Power Bar

Cord Caps

Tap Hanger

Cord

Double Cord

Power Feed

Hanger

Tap Hanger

Click!

Power Feed

Bushing

1XB01PT00x

Applies to Components:

Cord Caps

Tap Hanger

Notch