Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
3 of 26
Power Feed Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Single Cord Power Feed Hanger:
NOTE: Each Single Cord Power Feed Hanger only carries half of
the electrical circuit, and must be used in pairs. To avoid short-
circuiting the system, the spring contacts must point in different
directions.
1. Install the Single Cord Power Feed Hanger onto the Power Bar:
pass the Cord through the Power Bar, tip the Hanger 45 degrees
and insert the copper springs into the center of the Power Bar, then
push the Hanger up while tipping it back up 45 degrees (Fig. 1).
2. Cut the Cord to the desired length, and remove 10mm (3/8") of
insulation from the end of each Cord.
3. Twist the wire strands tightly, then insert the exposed wires into the
Power Feed Bushings. Secure by tightening the Set Screws with
the included Allen key.
Double Cord/Rod Power Feed Hanger:
1. Install the Double Cord (or Rod) Power Feed Hanger onto
the Power Bar: press down rmly on the top of the Power
Bar, while pressing up on the bottom of the Hanger, until the
Power Bar clicks into place (Fig. 2).
2. For Cords:
a. Cut the Cords to the desired length, and remove 10mm
(3/8") of insulation from the end of each Cord.
b. Twist the wire strands tightly, then insert the exposed wires
into the Power Feed Bushings. Secure by tightening the
Set Screws with the included Allen key.
3. For Rods:
a. Cut the Rods to the desired length, and remove 10mm
(3/8") paint from the end of each Rod using sand paper.
b. Insert the exposed Rod into the Power Feed Bushings.
Secure by tightening the Set Screws with the included
Allen key.
Fig. 1
Fig. 2
1XB01SC06x
1XB01SC20x
1XB01RC06x
1XB01RC20x
Applies to Components:
1XB01DC06x
1XB01DC20x
1XB01DR06x
1XB01DR12x
1XB01DR18x
Applies to Components:
Single Cord Power
Feed Hanger
Power Bar
Cord
Set Screw
Allen Key
Power Feed
Bushing
Double Cord Power
Feed Hanger
Double Rod Power
Feed Hanger
Power Bar
Cord
Rod
Set Screw
Allen
Key
Power Feed
Bushing
In-Line Double Cord Power Feed Hanger:
1. Cut the Cords to the desired length, and remove 10mm (3/8") of
insulation from the end of each cord.
2. Twist the wire strands tightly, then insert the exposed wires into the
Power Feed Bushings. Secure by tightening the Set Screws with the
included Allen key.
3. Press down rmly on the top of the Power Bar, while pressing up on
the bottom of the Hanger, until the Power Bar clicks into place (Fig. 3).
Repeat for the second Power Bar.
Note: The In-Line Double Cord Power Feed Hanger connects the two
Power Bars to the same electrical circuit. It does not increase the
wattage capacity of the Power Feed.
Fig. 3
In-Line Double Cord
Power Feed Hanger
Power Bar
Cord
Set Screw
Allen Key
Power Feed
Bushing
Applies to Components:
1XB01IC06x 1XB01IC20x