Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
17 of 26
Luminaires and Luminaire Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5
Connecting a Ladder Light onto a Luminaire Hanger:
NOTE: The Luminaire Hanger Endcap or a Luminaire must be installed before connecting a Ladder Light onto a Luminaire
Hanger.
1. Gently press both sides of the Ladder Light onto the Luminaire Hanger until the Ladder Light softly clicks into place (Fig. 6).
2. Conrm the desired position of the Ladder Light on the Hanger, and adjust the position if necessary.
CAUTION! The next step will put a set of small score lines through the paint on the Hanger Rods.
3. Place the index and middle ngers of each hand on the Hanger Rods on either side of the Ladder Light and press rmly on
both sides of the Ladder Light with the thumbs until the Ladder Light fully clicks into place (Fig. 7).
click!
CLICK!
Fig. 6
Fig. 7
Connecting a Luminaire Hanger Endcap to a Luminaire Hanger:
1. Gently insert the two Luminaire Hanger Rods into the holes on the top of the Luminaire Hanger Endcap (Fig. 1).
2. Rotate the Endcap or Luminaire Hanger 90 degrees (Fig. 2).
3. Push the Luminaire Hanger Rods into the Endcap until the copper on the ends of the Rods is no longer visible (Fig. 3).
4. Rotate the Endcap or Luminaire Hanger back 90 degrees (Fig. 4).
5. Pull the Endcap down to lock the Endcap (Fig. 5).
1XZ990001x
Applies to Component:
1XDXXLL01x
Applies to Component:
Rods
Endcap
Hanger
Ladder Light
Luminaire