Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
15 of 26
Leaf, Calla, Branches, Glass Cluster, V-Cord, and Monoline Luminaires:
1. Align Hanger with Power Bar (Fig. 1) and press down rmly on the top of the Power Bar, while
pressing up on the bottom of the Hanger, until the Power Bar clicks into place. (Fig. 2)
2. To remove, tilt hanger then pull down from Power Bar (Fig. 3).
3. Smooth cord by gently pulling it between thumb and forenger. Alternatively, place a rigid rod between thumb and cord,
such as the barrel of a pen or the shank of a screwdriver.
Fig. 1
Fig. 2
Fig. 3
Power Bar
Hanger
Monoline Luminaires
Applies to three cord hangers:
Leaf, Calla, Branches, and
Glass Cluster
V-Cord Luminaires
Luminaires and Luminaire Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Glass Cluster Luminaires:
1. Place the Triangle Spacer in
between the Cables of the
xture (Fig. 3). Snap the pendent Cables into the
Spacer at three locations (Fig. 4). Note: Make sure
Glass Luminaires are screwed on tightly.
Fig. 3
Fig. 4
Triangle
Spacer
Glass
Luminaires
Cable
Calla:
1. Curl the Petal into a conical shape and align
the two outer holes with each other (1).
2. Align Petal with the xture Branches (2).
3. Secure Petals to Branches by hand
screwing the two Pins onto the xture for
each Branch (3)
Applies to Components:
1XDXXCL14x-XX
1XDXXCL16x-XX
1XZ990007x
1XZ990010x
Fig. 2
Petal
Branches
Applies to Components:
1XDXXCL13x
1
2
3
1XDXXCLxxx-xx
1XDXXVCxxx-xx
Applies to Components:
Note: Use opposite hand to grasp cord above the region being smoothed. Do not apply excessive force, or damage to
cord and hanger may result.