Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
14 of 26
Luminaires and Luminaire Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Connecting a Parallel Luminaire Hanger to a Power Bar:
1. Place the Parallel Luminaire Hanger under the Power Bar.
2. Press up rmly on the bottom of the Parallel Luminaire Hanger, while pressing down on the top of the Power Bar, until
the Parallel Luminaire Hanger clicks into place (Fig. 1).
3. To remove, tip the Parallel Luminaire Hanger in the direction of the Power Bar to release the Snap Hooks, then pull the
Parallel Luminaire Hanger o the Power Bar (Fig. 3).
Connecting a Rotational Luminaire Hanger or Light Guide Disk Luminaire to a Power Bar:
1. Place the Rotational Luminaire Hanger Hub over the Power Bar.
2. Press down rmly on top of Hub, while pressing up on the bottom of the Power Bar, until the Hub clicks into place (Fig. 2).
3. Press the Hanger Rod up against the Hanger Hub and screw in the Hanger Cap. Be sure the brass contacts on the Hanger
Hub are touching those on the Hanger Rod (Fig. 3). NOTE: Do not fully tighten.
4. Rotate the Luminaire to the desired position and secure by fully tightening the Hanger Cap (Fig. 4).
Fig. 1
CLICK!
1XB04ARxxx
Applies to Components:
1XB04RDxxx 1XDXXRH07x
Applies to Components:
Fig. 4Fig. 2 Fig. 3
CLICK!
Hanger Hub
Hanger Rod
Hanger Cap
Parallel Luminaire
Hanger
Power Bar
Power Bar