Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
13 of 26
Luminaires and Luminaire Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Connecting a Double Rod Luminaire Hanger to a Power Bar:
1. Place the Luminaire Hanger over the Power Bar (Fig. 2).
2. Press down rmly on the top of the Luminaire Hanger, while pressing up on the bottom of the Power Bar, until the
Luminaire Hanger clicks into place (Fig 3).
3. To remove, tip the Luminaire Hanger in the direction of the Power Bar, then lift the Luminaire Hanger o the Power Bar.
Fig. 3
Fig. 2
Luminaire
Luminaire
Hanger
Power Bar
Connecting an RPxx Luminaire to an ARxx, RPxx, and DRxx Double
Luminaire Hanger (Fig. 1):
1. Gently insert the two Luminaire Hanger Rods into the holes on the top of the Luminaire.
2. Rotate the Luminaire or Luminaire Hanger 90 degrees.
3. Push the Luminaire Hanger rods into the Luminaire until the copper on the ends of the rods is no longer visible.
4. Rotate the Luminaire or Luminaire Hanger back 90 degrees to lock.
Fig. 1
Luminaire
Luminaire
Hanger
Luminaire
Hanger Rod
Applies to Components:
1XDXXRPxxx
1XB04ARxxx
1XB04DRxxx
1XB04DR16x-RG
1XB04RDxxx