Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
11 of 26
Power Bar Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Truss Hanger System:
1. Where applicable: Install the Mounting Bracket to the ceiling with Anchor (if applicable) and Screw, then screw the Post
onto the Mounting Bracket (Fig. 1).
2. Insert Extension or End Arm into the remaining slot of the Bracket and secure it with the provided Arm Flat Head Screw
(Fig. 2).
3. Where applicable: Insert the Cable into the Post and adjust to the desired length: to shorten, push the Cable up; to
lengthen, push in the Plunger while pulling down on the Cable, release the Plunger to lock. Cut o the excess Cable where
it exits the Post (Fig. 2).
4. Remove Cover Flat Head Screw and Bracket Cover and align Power Bar with the Bracket (Fig. 3).
5. Insert Power Bar onto the Bracket and reattach the Bracket Cover with Flat Head Screw (Fig. 4).
6. Repeat step 3 and 4 for each Bracket.
Fig. 1
Fig. 3
Fig. 4
1XB02TR06x-EN
1XB02TR06x-EX
1XB03TR16x-EN
1XB03TR16x-EX
1XB02TR20x-EN
1XB02TR20x-EX
1XZ05000xx
Applies to Components:
Anchor
Mounting
Bracket
Cable
Bracket
Extension
Kit Arms
Screw
Post
Cover Flat
Head Screw
Bracket
Cover
Power Bar
Bracket
Arm
End Kit Extension Kit
Double
Bracket
End Kit Arms
Cable
Arm Flat
Head Screw
Fig. 2
Sown in use Extension Kit with End Kit