Installation Sheet

June 10, 2019

10 of 26

Power Bar Hangers

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Perpendicular Power Bar Hanger v2:

1. Press down rmly on the top of the Power Bar Hanger, while pressing up on the bottom of the Power Bar, until the Power

Bar Hanger clicks into place (Fig. 2).

2. Push up on the bottom of the Power Bar Hanger Cover, while pressing down on the bottom of the Power Bar, until the

Power Bar Hanger Cover clicks into place (Fig. 3).

3. Pass top portion of the Perpendicular Power Bar Hanger over the end of the Power Bar and press down rmly on the top

of the Power Bar Hanger while pressing up on the bottom of the Power Bar, until the Power Bar Hanger clicks into place

(Fig. 3).

4. To remove the Power Bar Hanger Cover:

Spread the Power Bar Hanger Cover apart using the index and middle nger of each hand and pull down on the cover

while pushing up on the Power Bars with the thumbs.

Single and Double Rotational Power Bar Hanger:

1. Press down rmly on the top of the Power Bar Hanger Hub while pressing up on the bottom of the Power Bar, until the

Power Bar Hanger Hub clicks into place (Fig. 1).

2. Insert the Hanger Clip through the Hanger Hub and press up on the Hanger Clip until Hanger Clip clicks into place (Fig. 2).

3. Press the Hanger Rod up against the Hanger Hub and screw in the Hanger Sleeve. Be sure that the brass contacts on the

Power Bar Hanger Hub are touching those on the Hanger Rod (Fig. 3). NOTE: Do not fully tighten.

4. Rotate Power Bar to the desired position and secure by fully tightening the Hanger Sleeve (Fig. 4).

5. Repeat steps 1-4 for the second Power Bar.

Fig. 1 Fig. 2 Fig. 3

CLICK!

Fig. 4

Power Bar

Hanger Cover

Power Bar

Hanger Hub

Hanger Sleeve

Hanger Rod

Hanger Clip

1XB03PRxxx

Applies to Components:

1XB03RDxxx 1XB03RSxxx

Applies to Components:

Perpendicular

Power Bar

Hanger

Power Bar

Fig. 1 Fig. 2 Fig. 3