Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
9 of 26
Power Bar Hangers
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Perpendicular Power Bar Hanger:
1. Gently spread apart the Power Bar and insert the Rods of the Perpendicular Power Bar Hanger
through the Power Bar (Fig. 1).
2. Tip the Perpendicular Power Bar Hanger 45 degrees and insert the copper springs into the center of the Power Bar (Fig.
2).
3. Push the Perpendicular Power Bar Hanger up while tipping it back up 45 degrees (Fig. 2).
4. Pass top portion of the Perpendicular Power Bar Hanger over the end of the Power Bar and press down rmly on the top
of the Power Bar Hanger while pressing up on the bottom of the Power Bar, until the Power Bar Hanger clicks into place
(Fig. 3).
Parallel Power Bar Hanger:
1. Pass one end of the Parallel Power Bar Hanger over the end of a Power Bar (Fig. 1).
2. Press down rmly on the top of the Power Bar Hanger, while pressing up on the bottom of the Power Bar, until the Power
Bar Hanger clicks into place (Fig. 2).
3. Pass a second Power Bar between the rods of the Power Bar Hanger (Fig. 3).
4. Press down rmly on the top of the Power Bar, while pressing up on the bottom of the Power Bar Hanger, until the Power
Bar clicks into place (Fig. 4).
CLICK!
CLICK!
Fig. 1 Fig. 2 Fig. 3
Fig. 4
Fig. 2 Fig. 3
Fig. 1
1XB03ARxxx
Applies to Components:
1XB03ER18x
Applies to Components:
Parallel Power
Bar Hanger
Power Bar
Perpendicular
Power Bar Hanger
Power Bar