Installation & Assembly

2 of 2

December 27, 2017

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

New Edge LED Series - 24" LED Bath Bar, 32" LED Bath Bar, 40" LED Bath Bar

Important

• Always disconnect the power before installing and cleaning or other maintenance.

• Consult a qualiﬁed, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut o power to the outlet box (A).

2. Make appropriate electrical connections using

wire nuts:

a. Connect the LED driver’s (B) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s neutral wire (white) to the neutral outlet box wire.

c. Connect the xture’s (C) ground wire (green or uncoated) to the ground outlet box wire. If no ground is present in

outlet box, connect xture’s ground wire to the mounting plate (D) using the green screw (included).

d. Carefully place connections and LED driver in outlet box.

3. Attach the mounting plate (D) to the outlet box (A), secure with outlet box screws (E). Reinforce mounting plate with

additional screws and anchors appropriate for the mounting surface using the top and bottom slots (F).

4. Align holes on the xture (C) with studs (G) on mounting plate (D) and secure with large nuts (H).

5. Align holes on the glass diuser (J) and insert onto studs (K) on the xture (C), secure with silicone washers (L) and

small nuts (M).

6. Place the spine trims (N) over the small nuts (M) and secure with fastening screws (P).

7. Restore power to the outlet box (A).

Note

• The outlet box must be at least 4” DIA and 1.5” deep to ﬁt the LED driver.

• This ﬁxture is dimmable with Electronic Low Voltage (Trailing-Edge) type and Incandescent (Leading-Edge) type

dimmers. For best performance, we recommend using an Electronic Low Voltage dimmer.

3797, 3798, 3799

3797

3798 3799