Installation & Assembly

ManualsBrandsSonneman ManualsBathroom Vanity LightingThin-Line LED Bath Bar

2 of 2

January 2, 2018

Assembly Instructions 2814-3, 2814-4, 2814-6, 2814-8

INSTRUCTIONS D’INSTALLATION

Thin-Line Series - 3' LED Indirect Wall Bar, 4' LED Indirect Wall Bar, 6' LED Indirect Wall Bar, 8' LED Indirect Wall Bar

Important

• Always disconnect the power before installing and before cleaning or other maintenance.

• Consult a qualiﬁed, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut o power to the outlet box.

2. The LED driver (A) must be installed in a remote and accessible

location near the xture in accordance with local electrical code

(Fig. 1).

a. Connect the LED driver’s live wire (black) to the live supply

wire.

b. Connect the LED driver’s neutral wire (white) to the neutral

supply wire.

c. Connect the LED driver's positive (+) output wire (red) to

the necessary length of red wire (not included)

to reach the xture (B) location.

d. Connect the LED driver's negative (-) output wire (black)

to the necessary length of black wire (not included) to reach the

xture location.

3. Drill a small 1/4" hole (C) in the wall behind the xture (B).

and pull the low voltage wires through the wall.

4. Using the xture (B) as a template, install mounting screws (D)

with anchors (E). Do not tighten screws completely.

5. Pull the LED Driver's (A) positive (+) and negative (-) wires and

route through the wire hole (F) on xture (B).

Note: Either end of the xture can be connected to the driver.

The unused input wires must be capped o.

6. Hang xture (B) on the hooks (G), secure xture by tightening

mounting screws (D).

7. Make appropriate electrical connections using wire nuts:

a. Connect the positive (red) low voltage wire to the red xture

wire.

b. Connect the negative (black) low voltage wire to the black

xture wire.

c. Carefully place the connections in the xture's (B) end.

8. Slide in the covers (H) and secure with cover screws (J).

9. Restore power to the outlet box.

Note

• These ﬁxtures are dimmable with Electronic Low Voltage (Trailing-Edge) type dimmers and

Incandescent (Leading-Edge) type dimmers. For best performance, we recommend using an Electronic

Low Voltage Dimmer.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the ﬁnish, avoid any harsh abrasives or chemicals.

Fig. 1

Detailed View

2814-3

2814-4

2814-6

2814-8