Installation & Assembly

1. Shut o power to the outlet box (A).

2. Place studs (B) through holes in glass (C) and silicone washers (D). Tighten with cap nuts (E). (Fig. 1)

3. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (F) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s (F) neutral wire (white) to the neutral outlet box wire.

c. Connect xture’s ground wire (green or uncoated) to the ground outlet

box wire. If no ground is present in outlet box, connect xture’s ground

wire to the mounting plate (G) using the green screw (included).

d. Carefully place connections and LED driver (F) in outlet box (A). (Fig. 1)

4. Attach the mounting plate (G) to the outlet box (A), secure with outlet box screws (H). (Fig. 1)

For Wet Location Installation: Fixture must be installed in the orientation shown, and mounted minimum 4' above the ground.

5. Install the back plate (I) to the mounting plate (G) by hooking the bend (J) onto the bar (K) in the back plate.

Secure with mounting screw (L) using included Allen wrench (M). (Fig. 2)

6. For Wet Location Installation: Place a small bead of silicone or water proof caulk (not included)

around the back plate (I) where it comes into contact with the wall.

7. Restore power to the xture.

December 3, 2015

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Midtown Series - Short LED Sconce, Tall LED Sconce

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

2724, 2725

Note

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) and Incandescent (Leading-Edge) type dimmers.

For best performance, we recommend using an Electronic Low Voltage dimmer.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

Fig. 1 Fig. 2

Continued 2 of 2