Installation & Assembly

1. Shut o power to the outlet box (A).

2. Make appropriate electrical connections using wire nuts:

a. Connect the transformer’s (B) live wire (black) to the live outlet box wire.

b. Connect the transformer’s (B) neutral wire (white) to the neutral outlet box wire.

c. Connect xture’s ground wire (green or uncoated) to the ground outlet

box wire. If no ground is present in outlet box, connect xture’s ground

wire to the mounting plate (C) using the green screw (included).

d. Carefully place connections and transformer (B) in outlet box (A).

3. Attach the mounting plate (C) to the outlet box (A), secure with outlet box screws (D). Use anchors (E)

and screws (F) to secure ends of mounting plate to the mounting surface.

For Wet Location Installation: Fixture must be installed in the orientation shown, and mounted minimum 4’ above the ground.

4. Install the back plate (G) to the mounting plate (C) by hooking the bend (H) on the top of the back plate

onto the mounting plate. Use included Allen wrench (I) to tighten the set screws (J) to secure.

5. For Wet Location Installation: Place a small bead of silicone or water proof caulk (not included)

around the back plate (G) where it comes into contact with the wall.

6. Restore power to the xture.

December 3, 2015

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Folds Series - Tall LED Sconce

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

2711

Note

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

Continued 2 of 2