Installation Sheet

March 09, 2016
©2016 SONNEMAN - A Way of Light
28 of 29
Power Bar Hanger Installation
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Perpendicular Power Bar Hanger:
1. Gently spread apart the Power Bar and insert the rods of the Perpendicular Power Bar Hanger through the Power Bar. (Fig. 3)
2. Tip the Perpendicular Power Bar Hanger 45 degrees and insert the copper springs into the center of the Power Bar. (Fig. 4)
3. Push the Perpendicular Power Bar Hanger up while tipping it back up 45 degrees. (Fig. 4)
4. Attach the second Power Bar the same way as for the Parallel Power Bar Hanger. (Fig. 5)
Parallel Power Bar Hanger:
1. Pass one end of the Parallel Power Bar Hanger over the end of a Power Bar. (Fig. 1)
2. Press down rmly on the top of the Power Bar Hanger, while pressing up on the bottom of the Power Bar, until the Power
Bar Hanger clicks into place. (Fig. 1)
3. Pass a second Power Bar between the rods of the Power Bar Hanger. (Fig. 2)
4. Press down rmly on the top of the Power Bar, while pressing up on the bottom of the Power Bar Hanger, until the Power
Bar clicks into place. (Fig. 2)
CLICK!
CLICK!
Fig. 1
Fig. 2
Fig. 4 Fig. 5
Fig. 3