Installation Sheet

March 09, 2016

26 of 29

Ceiling Hanger Assembly

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Rod Ceiling Hanger Assembly:

1. Install the mounting bracket to the ceiling with anchor and screw, then screw the post onto the mounting bracket. (Fig. 1)

2. Pass the Ceiling Hanger rod through the Power Bar, then through the center hole of the cover, making sure the counter-sunk

holes on the cover are facing up. Attach the cover to the Ceiling Hanger using the two small Phillips screws. (Fig. 2)

3. Cut the rod to the desired length, then insert the rod into the post and tighten the set screw with the Allen key. (Fig. 3)

Cable Ceiling Hanger Assembly:

1. Install the mounting bracket to the ceiling with anchor and screw, then screw the post onto the mounting bracket. (Fig. 4)

2. Pass the Ceiling Hanger cable through the Power Bar, then through the center hole of the cover, making sure the counter-

sunk holes on the cover are facing up. Attach the cover to the Ceiling Hanger using the two small Phillips screws. (Fig. 5)

3. Insert the cable into the post and adjust to the desired length: to shorten, push the cable up; to lengthen, push in the

plunger while pulling down on the cable, release the plunger to lock. Cut o the excess cable where it exits the post. (Fig. 6)

Fig. 1

Fig. 4

Fig. 2

Fig. 5

Fig. 3

Fig. 6