Installation Sheet

March 09, 2016

22 of 29

Minibox Wall Power Feed Installation

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

12. Feed the Minibox into the wall opening at a slight angle (Fig. 3) until the side tabs (H)

are pressed against the mounting surface. (Fig. 3)

17. While keeping the side tabs (H) pressed against the mounting surface, secure the

Minibox to the mounting surface by tightening the two mounting screws (G). (Fig. 4)

18. Make appropriate electrical connections using wire nuts: Connect one of the black

Power Feed wires to one of the transformer output wires. Connect the other black

Power Feed wire to the second transformer output wire. Carefully place connections

in the Minibox. (Fig. 5)

19. Attach mounting bracket (J) to Minibox with two mounting screws (K). (Fig. 5)

20. Attach Power Feed (L) to mounting bracket (J). Secure using set screw (M) and

included Allen key (N). (Fig. 6)

Note

• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse Phase) type dimmers ONLY.

Fig. 3

Fig. 5 Fig. 6

Fig. 4