Installation Sheet

June 10, 2019
©2019 SONNEMAN - A WAY OF LIGHT
25 of 26
Note
• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse
Phase) type dimmers ONLY.
Note
• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse
Phase) type dimmers ONLY.
Deep Power Feed Installation (Fig. 2):
1. Shut o power to the outlet box.
2. Attach the Crossbar to the outlet box using
the two (2) long Screws.
3. Make appropriate electrical connections using wire nuts:
a. Connect the Transformer's live wire (black) to the live Outlet
Box wire.
b. Connect the Transformer's neutral wire (white) to the neutral
outlet box wire.
c. Connect the ground outlet box wire (green or uncoated) to
the crossbar using the green screw.
d. Connect one of the Power Feed wires to one of the
transformer output wires. Connect the other Power Feed wire to
the second transformer output wire.
e. Carefully place connections in outlet box.
4. For 300W Transformers: Attach the Transformer to the Power
Feed using the two (2) Small Screws.
For 60W and 75W Transformers: Place the Transformer inside
the Power Feed.
5. Install the Power Feed to the Crossbar by passing the Threaded
Nipple through the hole in the Power Feed and securing with
the Canopy Nut.
Shallow Power Feed Installation (Fig. 1):
1. Shut o power to the Outlet Box.
2. For remote transformer use: The
Transformer must be installed in an accessible location in
accordance with local electrical codes. You must use the
appropriate wire gauge from the transformer to the Power Feed
to limit the voltage drop to less than 5%.
3. Make appropriate electrical connections using wire nuts:
a. Connect the Transformer's live wire (black) to the live Outlet
Box wire.
b. Connect the Transformer's neutral wire (white) to the neutral
Outlet Box wire.
c. Connect the ground outlet box wire (green or uncoated) to
the crossbar using the green screw.
d. Connect one of the Power Feed wires to one of the
Transformer output wires. Connect the other Power Feed wire to
the second Transformer output wire.
e. Carefully place connections and Transformer (if applicable) in
Outlet Box.
4. Attach the Crossbar to the Outlet Box using the two (2) long
Screws.
5. Install the Power Feed to the Crossbar by passing the Threaded
Nipple through the hole in the Power Feed and securing with the
Canopy Nut.
Fig. 2
Outlet Box
Crossbar
Threaded Nipple
Canopy Nut
Screw
Small Screw
Transformer
Power Feed
Fig. 1
Outlet Box
Transformer
Power Feed
Crossbar
Screw
Threaded Nipple
Canopy Nuts
1XA01SG20x
Applies to Components:
Applies to Components:
1XA01SG05x
Power Feed Installation
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Important
• Always disconnect the power before installing or replacing components and before cleaning or other
maintenance.
• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.
Consulter un électricien qualifié pour vous assurer que les conducteurs de la dérivation sont adéquats.
Note: For alternative Power Feed Installation see attached Appendix A.