Installation Sheet

June 10, 2019

26 of 26

Note

• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse Phase) type dimmers ONLY.

1. Shut off power to the outlet box.

2. Assemble the Power Feed as shown on page 25.

3. Determine desired hanging height, and cut the Support Cables to length plus 3 inches. Connect the Inner Ring Power

Bar to the Power Feed by inserting the support cables into the Grippers and adjusting to the desired length: to shorten,

push the cable up; to lengthen, push in the Gripper Plunger while pulling down on the cable, release the plunger to lock.

Connect the inner ring Cord Power Feed Hangers to the Power Feed as shown on page 3.

Note: The inner Ring Power Bar cables and cords should connect to the inner set of Power Feed Bushings and Grippers.

4. Repeat Step 3 for the Outer Ring Power Bar.

Note: The outer Ring Power Bar Cables and Cords should connect to the outer set of Power Feed Bushings and Grippers.

5. Connect the Luminaire Hangers to the Ring Power Bars as shown on pages 13-21.

6. Connect the Luminaires to the Luminaire Hangers as shown on pages 13-21.

7. Restore power to the outlet box.

Power Feed

Outer Ring Power Bar

Suspenders

- Double Ring Configuration

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Important

• Always disconnect the power before installing or replacing components and before cleaning or other

maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

Inner Ring Power Bar

Cord Power

Feed Hanger

Luminaire Hanger

Gripper

Support Cable

Luminaire