Installation Sheet

March 09, 2016
©2016 SONNEMAN - A Way of Light
18 of 29
Tandem Power Feed Installation
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Important
• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.
Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.
Deep Power Feed Installation (Fig. 1):
1. Shut o power to the outlet box (A).
2. Attach the mounting plate (B) to the outlet box (A) using the two
(2) long Phillips screws (C).
3. Make appropriate electrical connections using wire nuts:
a. Connect the transformer's (D) live wire (black) to the live
outlet box wire.
b. Connect the transformer's neutral wire (white) to the neutral
outlet box wire.
c. Connect the ground outlet box wire (green or uncoated) to
the mounting plate using the green screw.
d. Connect one of the black Power Feed (E) wires to one of the
transformer output wires. Connect the other black Power Feed
wire to the second transformer output wire.
e. Carefully place connections in outlet box (A).
4. For 150W and 300W transformers: Attach the transformer (D)
to the Power Feed (E) using the two (2) small pan head screws (F).
For 60W and 75W transformers: Place the transformer inside
the Power Feed.
5. Install the Power Feed (E) to the mounting plate (B) using the four
(4) counter-sunk Phillips screws (G).
Shallow Power Feed Installation (Fig. 2):
1. Shut o power to the outlet box (A).
2. For remote transformer use: The transformer (D) must be
installed in an accessible location in accordance with local
electrical codes. You must use the appropriate wire gauge from
the transformer to the Power Feed to limit the voltage drop to
less than 5%.
3. Make appropriate electrical connections using wire nuts:
a. Connect the transformer's (D) live wire (black) to the live
outlet box wire.
b. Connect the transformer's neutral wire (white) to the neutral
outlet box wire.
c. Connect the ground outlet box wire (green or uncoated) to
the mounting plate (B) using the green screw.
d. Connect one of the black Power Feed (E) wires to one of the
transformer output wires. Connect the other black Power Feed
wire to the second transformer output wire.
e. Carefully place connections and transformer (if applicable) in
outlet box (A).
4. Attach the mounting plate (B) to the outlet box (A) using the two
(2) long Phillips screws (C).
5. Install the Power Feed (E) to the mounting plate (B) using the four
(4) counter-sunk Phillips screws (G).
Fig. 1
Fig. 2
Note
• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse Phase) type dimmers ONLY.
A
A
D
B
C
G
E
B
C
D
E
G
F