Installation Sheet

March 09, 2016

11 of 29

1. Shut off power to the outlet box.

2. Assemble the Power Feed (A) as shown on page 17.

3. Determine desired hanging height, and cut the support cables (B) to length plus 3 inches. Connect the Ring Power Bar (C)

to the Power Feed (A) by inserting the support cables into the grippers (D) and adjusting to the desired length: to shorten,

push the cable up; to lengthen, push in the gripper plunger while pulling down on the cable, release the plunger to lock.

4. Connect the Cord Power Feed Hangers (E) to the Power Feed (A) as shown on page 25.

5. Connect the Luminaire Hangers (F) the Ring Power Bar (C) as shown on page 29. (Fig. 3)

6. Connect the Luminaires (G) to the Luminaire Hangers (F) as shown on page 29. (Figs. 1-2)

7. Restore power to the outlet box.

Suspenders™ - Single Ring Conguration

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

Note

• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse Phase) type dimmers ONLY.