Installation Sheet
June 16, 2019
©2019 SONNEMAN - A WAY OF LIGHT
25 of 26
Power Feed Installation
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Important
• Always disconnect the power before installing or replacing components and before cleaning or other
maintenance.
• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.
Consulter un électricien qualifié pour vous assurer que les conducteurs de la dérivation sont adéquats.
Deep Power Feed Installation (Fig. 1):
1. Shut o power to the outlet box.
2. Attach the Crossbar to the outlet box using the
two (2) long Screws.
3. Make appropriate electrical connections using wire nuts:
a. Connect the Transformer's live wire (black) to the live Outlet Box
wire.
b. Connect the Transformer's neutral wire (white) to the neutral outlet
box wire.
c. Connect the ground outlet box wire (green or uncoated) to the
crossbar using the green screw.
d. Connect one of the Power Feed wires to one of the transformer
output wires. Connect the other Power Feed wire to the second
transformer output wire.
e. Carefully place connections in outlet box.
4. For 300W Transformers: Attach the Transformer to the Power Feed
using the two (2) Small Screws.
For 60W and 75W Transformers: Place the Transformer inside the
Power Feed.
5. Install the Power Feed to the Crossbar by passing the Threaded Nipple
through the hole in the Power Feed and securing with the Canopy Nut.
Shallow Power Feed Installation (Fig. 2):
1. Shut o power to the Outlet Box.
2. For remote transformer use: The Transformer must
be installed in an accessible location in accordance with local electrical codes.
You must use the appropriate wire gauge from the transformer to the Power
Feed to limit the voltage drop to less than 5%.
3. Make appropriate electrical connections using wire nuts:
a. Connect the Transformer's live wire (black) to the live Outlet Box wire.
b. Connect the Transformer's neutral wire (white) to the neutral Outlet Box
wire.
c. Connect the ground outlet box wire (green or uncoated) to the crossbar
using the green screw.
d. Connect one of the Power Feed wires to one of the Transformer output
wires. Connect the other Power Feed wire to the second Transformer output
wire.
e. Carefully place connections and Transformer (if applicable) in Outlet Box.
4. Attach the Crossbar to the Outlet Box using the two (2) long Screws.
5. Install the Power Feed to the Crossbar by passing the Threaded Nipple
through the hole in the Power Feed and securing with the Canopy Nut.
Fig. 2
Note
• This fixture is dimmable with Electronic Low Voltage (i.e., Trailing-Edge/Reverse Phase) type dimmers ONLY.
Outlet Box
Transformer
Power Feed
Crossbar
Screw
Threaded
Nipple
Canopy Nuts
1XA01DB20x
Applies to Components:
Applies to Components:
1XA01DB05x
Fig. 1
Outlet Box
Crossbar
Threaded Nipple
Canopy Nut
Screw
Small Screw
Transformer
Power Feed