Installation & Assembly

2 of 2

October 20, 2016

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Abstract Rhythms Series - LED Pendant

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Determine the height at which the xture is to be hung. Insert the

steel cable (B) through the lock (C) and adjust to the desired length.

To shorten the cable, push the cable (B) up and it will be locked

automatically. To lengthen the cable, lift up on the cable and push

up on the lock (C). While keeping the lock depressed, lower the cable

to the desired length. Release the lock to set (Fig. 1).

3. Use the screwdriver (D) to loosen the set screw (E). Adjust the power

cord (F) to the desired length. Secure the set screw to set.

4. Loosen the screws on the safety cable coupling (G) and undo

the loop. Pass the safety cable through a hole on the mounting plate (H)

and insert the end back through the coupling to form

a loop. Tighten the coupling screws to secure the safety cable. (Fig. 2).

5. Attach the mounting plate (H) to the outlet box (A), secure with

outlet box screws (J).

6. Reserve LED driver (K), extra cord (F), and cable (B) in the canopy (L).

7. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (K) live wire (black) to the

live outlet box wire.

b. Connect the LED driver’s (K) neutral wire (white) to

the neutral outlet box wire.

c. Connect the xture’s ground wire (green or uncoated)

to the ground outlet box wire.

d. Carefully place connections in outlet box (A).

8. Install the canopy (L) to the mounting plate (H)

using the mounting screws (M).

9. Restore power to the xture.

Note

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge), and 0-10V type

dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

2695

Fig. 1

Fig. 2