Installation Guide

ManualsBrandsSonneman ManualsLampsSonneman E-Tenda 19" Tall 1 Light Desk Lamp

Important: Always unplug the power cord before installing or replacing bulb and before cleaning or other maintenance.

HEIGHT ADJUSTMENT

•To increase height of lamp, loosen the Clutch and carefully

pull up on the Upper Stem. Tighten the Clutch once lamp is

at desired height. (Fig. A)

•To decrease height of lamp, loosen the Clutch and

carefully push down on the Upper Stem while gently pulling

the power cord free from the Lower Stem. Tighten the

Clutch once lamp is at desired height.

Assembly Instructions for: item 7014

Series E - Tenda Swing Arm Table Lamp

LAMP ASSEMBLY

BULB INSTALLATION/REPLACEMENT (Fig. B)

1. Remove bulb from box. Hold the bulb by using protective

cloth. Push bulb into the socket. The socket is spring loaded.

NOTE: DO NOT TOUCH THE GLASS PART OF THE BULB WITH

BARE HANDS. Oil from fingerprints will reduce life of the bulb.

FIG. B

high-low switch

base

lower stem

upper

stem

socket tube

handle

shade

power cord

mounting stud

FIG. A

clutch

FIG. C

SHADE INSTALLATION (Fig. C)

1. Slide Shade Socket Tube. Make sure slot in Teflon Ring

aligns with shade hole.

2. Secure Shade to Socket Tube by screwing in hex screw

with hex key provided.

1. Screw lower stem of lamp on to base (Fig. A)

FIG. A

Important Safety Instructions Lighted lamp is HOT!

1. Disconnect and allow to cool for at least 5 minutes before

replacing bulb.

2. Bulb gets HOT quickly! Be sure power is off when re-lamping.

3. Do not touch hot enclosure.

4. Do not direct light at persons.

5. Do not look directly at lighted bulb.

6. Keep lamp away from curtains, draperies, and similiar

materials.

7. Use only a 120v, 75watt, G9 base, xenon bulb.

8. Do not touch bulb at any time. Use a soft cloth to clean. Oil

from skin may damage bulb integrity.

9. Do not operate the lamp with damaged or missing shield.

10. Damaged shields should be replaced before lamp is used.

FIG. D

G9 xenon bulb