Installation & Assembly

2 of 2

November 15, 2019

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Vines Series - Small LED Pendant

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut o power to the outlet box (A).

2. Determine the height at which the xture is to be hung. Insert the

steel cable (B) through the lock (C) and adjust to the desired length. To

shorten the cable, push the cable (B) up and it will be locked

automatically. To lengthen the cable, lift up on the cable and push up

on the lock (C). While keeping the lock depressed, lower the cable to

the desired length. Release the lock to set. Slide cord rings (D) as close to

canopy (E) and xture (F) as possible. (Figure 1)

3. Use the screwdriver to loosen the slotted set screw (G). Adjust height of

cord. Tighten the set screw to set. Reserve extra cord in the canopy (E).

4. Make appropriate electrical connections using wire nuts (Appendix A):

a. Connect the LED driver’s (H) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s (H) neutral wire (white) to the neutral outlet

box wire.

c. Connect the canopy's ground wire (green or uncoated) to the ground

outlet box wire. If no ground is present in outlet box, connect canopy's

ground wire to the mounting plate (J) using the green screw (included).

d. Connect the xture inner conductor to the red driver output wire and

connect the xture outer conductor to the black driver output wire.

e. Carefully place connections and LED driver in outlet box.

5. Attach the mounting plate (J) to the outlet box (A), secure with

outlet box screw (K).

6. Attach canopy (E) to the mounting plate (J), secure with screws (L).

7. Attach glass (M) to xture (F). Secure with set screw (N).

8. Restore power to the outlet box (A).

Note

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) , Incandescent (Leading-Edge), 0-10V type

dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

3281

(Figure 1)