Installation Sheet

2 of 2

January 16, 2018

Assembly Instructions 3802, 3803, 3805

INSTRUCTIONS D’INSTALLATION

Crystal Rods Series - 4-Light LED Bath Bar, 6-Light LED Bath Bar, 10-Light LED Bath Bar

Important

• Always disconnect the power before installing and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut o power to the outlet box.

2. The LED driver (A) must be installed in a remote and accessible location

near the xture in accordance with local electrical code. (Fig. 1)

a. Connect the LED driver’s live wire (black) to the live supply wire.

b. Connect the LED driver’s neutral wire (white) to the

neutral supply wire.

c. Connect the LED driver's positive (+) output wire (red) to the necessary

length of red wire (not included) to reach the xture location.

d. Connect the LED driver's negative (-) output wire (black) to the

necessary length of black wire (not included) to reach the xture location.

3. Drill a small hole (B) in the wall behind the xture and pull the

low voltage wires through the wall.

4. Attach the mounting plate (C) to the structure, secure with

drywall screws (D) and drywall anchors (E).

5. Make appropriate electrical connections using wire nuts:

a. Connect the positive (red) low voltage wire to the red xture wire.

b. Connect the negative (black) low voltage wire to the black

xture wire.

c. Carefully place the connections in the xture (F).

6. Install the xture (F) to the mounting plate (C) by aligning two

mounting holes (G) with studs (H) on the mounting plate.

Secure with nials (J).

7. Restore power to the xture.

Note:

• 3802 & 3803: These xtures are dimmable with Electronic Low Voltage (Trailing-Edge) type dimmers and

Incandescent (Leading-Edge) type dimmers. For best performance, we recommend using an Electronic

Low Voltage Dimmer.

• 3805: This xture is dimmable with ELV (Trailing-Edge), Incandescent (Leading-Edge), and 0-10V type dimmers only.

Care Instructions:

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

3802

Fig. 1

3805

3803