Installation Sheet

November 15, 2019

2 of 3

1. Shut o power to the outlet box (A).

2. Refer to the corresponding pendant cordset assembly instructions for any pendant

preparation steps (if applicable).

3. Determine the height at which each pendant is to be hung. Use the

screwdriver (B) to loosen the set screw (C). Feed the power cords (D) through the

bushings (E) on the canopy (F). Adjust the cord (D) to the desired length. Tighten

the set screw to set.

4. Connect the xture wires to the lever nuts (G) by pulling up on the lever for an

empty slot (Fig. 1), inserting the wire, and pushing the lever back down to lock.

The inner stranded conductor (H) and the outer braided conductor (J) on each

cord (D) must be connected to separate lever nuts, as shown (Fig. 2). Reserve extra

cords (D) and lever nuts (G) in the canopy (F). If shortening of the cords is necessary

refer to Appendix A.

5. Attach cross bar (L) to the outlet box (A), secure with outlet box screws (M).

6. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (K) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s neutral wire (white) to the neutral outlet box wire.

c. Connect the xture's ground wire (green or uncoated) to the ground outlet box wire.

d. Carefully place connections and LED driver in the canopy.

7. Attach canopy (F) to nipple (N), secure with washer and nial (P).

8. Complete xture assembly per the corresponding pendant assembly instructions.

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

3-Light Round Canopy Kit

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

CPY.003.xx

Note

• See marking on the LED Driver for compatible

dimmer types.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh

abrasives or chemicals.

Fig. 2

Fig. 1

DRIVER

POSITIVE (+)

NEGATIVE (-)