Installation & Assembly

January 13, 2020

3 of 3

Connector Types and Installation

1. Using main xture (C) as a template, line up corresponding connector (J) at desired angle. Note: Notches (K) on xture

limit position of connector (Fig2).

2. Once connector (J) is at approproate angle, secure connector in place using anchors (E) and screws (F).

3. Install the second xture using the connector as a template. Remove ground screw from mounting plate (C) so that

xture can sit ush against the wall.

4. Connect wires (L) between xtures (C) by inserting them into ports (M) and running them through connectors.

5. Continue repeating installation process for xture (C) and connectors (J) until desired pattern is complete. Note: Only

use the connecting wires when installing multiple xtures on the same power supply.

CON.2191.xx-SS

CON.2191.xx-SM

CON.2191.xx-MM

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Coral Surface Series - Connectors

Important

• Always disconnect the power before installing and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

Fig. 2

CON.2191.xx-SM CON.2191.xx-SS CON.2191.xx-MM