Installation & Assembly

©2019 SONNEMAN - A WAY OF LIGHT
2 of 2
November 15, 2019
Assembly Instructions
INSTRUCTIONS D’INSTALLATION
Vines Series - Large LED Pendant
Important
• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.
Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.
1. Shut o power to the outlet box (A).
2. Determine the height at which the xture is to be hung. Insert the steel cable (B) through the lock (C) and adjust
to the desired length. To shorten the cable, push the cable (B) up and it will be locked automatically. To lengthen
the cable, lift up on the cable and push up on the lock (C). While keeping the lock depressed, lower the cable to
the desired length. Release the lock to set. Slide cord rings (D) as close to canopy (E) and xture (F)
as possible. (Figure 1)
3. Use the screwdriver to loosen the slotted set screw (G). Adjust height of cord. Tighten the set screw to set.
Reserve extra cord in the canopy (E).
4. Make appropriate electrical connections using wire nuts (Appendix A):
a. Connect the LED driver’s (H) live wire (black) to the live outlet box wire.
b. Connect the LED driver’s (H) neutral wire (white) to the neutral outlet box wire.
c. Connect the canopy's ground wire (green or uncoated) to the ground outlet box wire. If no ground is present in
outlet box, connect canopy's ground wire to the mounting plate (J) using the green screw (included).
d. Connect the xture inner conductor to the red driver output wire and connect the xture outer conductor to
the black driver output wire.
e. Carefully place connections
and LED driver in outlet box.
5. Attach the mounting plate (J) to
the outlet box (A), secure with
outlet box screw (K).
6. Attach canopy (E) to the mounting
plate (J), secure with screws (L).
7. Install the mounting brackets (M)
to the ceiling with anchors (N)
and screws (P), then screw the
posts (Q) onto the mounting
brackets. Adjust the steel cables (B)
to level the xture (F). To shorten
the cable, push the cable up; to
lengthen, push in the plunger
while pulling down on the cable,
release the plunger to lock.
8. Attach glass (R) to xture (F). Secure with
set screw (S).
9. Restore power to the outlet box (A).
Note
• This xture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge), and 0-10V type
dimmers only.
Care Instructions
• Dusting: Use a clean, dry cloth.
• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.
3285
A
D
C
G
E
F
B
H
J
P
K
L
M
N
Q
R
S
(Figure 1)