Installation Sheet

1. Shut oﬀ power to the outlet box.

2. The LED driver (A) must be installed in a remote and accessible location near the xture in accordance with local electrical code. (Fig. 1)

a. Connect the LED driver’s live wire (black) to the live supply wire.

b. Connect the LED driver’s neutral wire (white) to the neutral supply wire.

c. Connect the LED driver's positive (+) output wire (red) to the necessary length of red wire (not included) to reach the xture location.

d. Connect the LED driver's negative (-) output wire (black) to the necessary length of black wire (not included) to reach the xture location.

e. (2334, 2338 only) If not using the 0-10V dimming fuction, cap oﬀ the purple and grey dimming wires.

3. Before removing the brackets (B) from the xture (C), place the xture against the wall and mark the location of the brackets on the wall.

4. Use the Allen key (D) to loosen the set screws (E) and remove the brackets (B).

5. Attach the brackets (B) to the wall with anchors (F) and screws (G) in the locations marked in Step 2.

6. Drill a small hole (H) in the wall behind the xture and pull the low voltage wires through the wall.

7. Make appropriate electrical connections using wire nuts:

a. Connect the positive (red) low voltage wire to the inner conductor of the xture cord.

b. Connect the negative (black) low voltage wire to the braided outer conductor of the xture cord.

c. Carefully push the connections and extra wires back through the hole (H) in the wall.

8. Lay the xture cord into the hooks (I) on the brackets (B), and attach the xture (C) to the brackets (B) by using the Allen key (D)

to tighten the set screws (E) against the hooks. (Fig. 2)

7. Restore power to the xture.

February 06, 2015

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Stiletto Lungo Series - 48" LED Wall Bar, 60" LED Wall Bar, 72" LED Wall Bar, 96" LED Wall Bar

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

2330, 2332, 2334, 2338

Continued 2 of 2

Note

• 2330, 2332: This xture is dimmable with Electronic Low Voltage (Trailing-Edge) and Incandescent (Leading-Edge)

type dimmers only. For best performance, use an Electronic Low Voltage dimmer.

• 2334, 2338: This xture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge), and

0-10V type dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

H F

Fig. 1

Fig. 2