Installation Sheet

February 21, 2019
©2019 SONNEMAN - A WAY OF LIGHT
5 of 5
Note
• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) and Incandescent (Leading-Edge) dimmers. Also
dimmable with 0-10 V type dimmers for systems consisting of 4 or more xtures.
Care Instructions
• Dusting: Use a clean, dry cloth.
• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.
6. Make appropriate electrical connections between branch circuit conductors and LED driver (B) using the provided wire nuts or
equivalent:
Note: The LED driver must be installed in a remote and accessible location near the xture in accordance with local
electrical code (Fig. 6).
a. Connect the LED driver’s live wire (black) to the live supply wire.
b. Connect the LED driver’s neutral wire (white) to the neutral supply wire.
c. Connect the LED driver’s positive (+) output wire to the necessary length of red wire (not included) to reach the xture input
wire location.
d. Connect the LED driver’s negative (-) output wire to the necessary length of black wire (not included) to reach the xture
input wire location.
e. Pull the low voltage driver output wires through the wall.
7. Make appropriate electrical connections between LED driver (B) and xture (A) using wire nuts:
a. Connect the positive (red) low voltage driver output wire to the red xture wire.
b. Connect the negative (black) low voltage driver output wire to the black xture wire.
c. Push wires and connections back into the wire hole.
8. For connecting multiple xtures together (if applicable), make appropriate electrical connections between xtures using wire
nuts:
a. Pull red and black wires (not included) from the output location(s) of the rst xture to the input location of the next xture(s)
b. Connect the positive (red) wire from the rst to the red wire of the next xture.
c. Connect the negative (black) wire from the rst to the black wire of the next xture.
d. Push wires and connections back into the wire hole.
9. Mount the xture (A) by using bracket mounting screws (K) and drywall anchors (M), then snap mounting bracket cover (N) onto
each mounting bracket (J).
10. Install triangle cover (P) onto the xture (A). Note: Cover is held in place magnetically.
11. Restore power to the branch circuit when the entire system is assembled.
Fig. 6
B
2182-S 2181-L2181-M