Installation Sheet

February 21, 2019

2 of 5

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Abstract Series - Small LED Surface Mount, Medium LED Surface Mount, Large LED Surface Mount

Important

• Always disconnect the power before installing or replacing parts and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

2181-S, 2182-M, 2183-L

1. Shut o power to the branch circuit conductors.

2. Layout the location(s) where the xtures (A) and remote driver (B) are to be installed and identify which arm(s) is to be used as

input(s) (C) and which arm(s) are to be used as output(s) (D). Cut o unused cables at the xture and discard (Fig. 1-2). Note:

Each of the three arms are wired to the xture with low-voltage coaxial cables (E). Any one cable can be used as the input and

the others may be used as an output to connect another Abstract xture up to the maximum wattage of your LED driver. When

connecting multiple xtures to another, it is recommended to install connecting arms at a location that is between the same

two studs (Fig. 1).

Stud

Fig. 1

C/F

A(1)

A(2)

D/F

C/F

Fig. 2