Installation Sheet

Arm Key

Hub Key

PWR

10½" (60)

11x

December 16, 2019

3 of 13

Step 1

a. Attach all C1 arms to an H5 Hub, as shown in Fig. 2.

Install each Arm into an LED Hub by fully inserting the Arm into a Neck on the Hub (Fig. 1). After each Arm is connected

to the Hub, install the M2 Set Screw into the Neck of the Hub, using the Small Hex Wrench provided, and tighten until it

comes in contact with the plastic cap on the Arm. DO NOT OVERTIGHTEN THE SCREWS.

b. Repeat for all H5 Hubs, including the Powered Hub. Set aside the Powered Hub with Arms for Step 9.

c. Fig. 3 shows this step in the context of the assembly as a whole.

Fig. 2

Fig. 3

Small Hex Wrench

Neck

M2 Set Screw

Arm

Fig. 1