Installation Sheet

Arm Length Key

12¼" (5)

December 16, 2019

10 of 13

Step 8

a. Slide Hanger Clips onto three of the remaining C2 Arms, then use the provided large

Hex Wrench to tighten the Screw, as seen in Fig. 19.

b. Connect the open H6 hubs using the remaining C2 Arms as shown in Fig. 16.

Note: Hanger Clips must be positioned as shown in Fig. 18.

c. Fig. 17 shows this step in the context of the assembly as a whole.

IMPORTANT:

Be sure to install all

M2 Set Screws to secure

the Arms to the Hubs,

as shown on page 5.

Fig. 16

Fig. 18

Fig. 17

Arm

Hang Clip

Screw

Large Hex Wrench

Fig. 19