Installation Sheet

November 20, 2018

9 of 12

SECTION 2

Stay Clip 2

Fig. 5a

Fig. 5b

a. Build this section using the 45° Hubs labeled Section 2 in the Hubs box, and Connecting Arms from the Section 2 box.

b. Start by connecting the C8 Arm to a Linear Hub (2a) then pass this arm through Stay Clip 2 (Fig. 5a), refer to Stay Clip

instructions on page 6, and continue by connecting a Linear Hub (2b) and a C4 Arm.

c. Continue adding Hubs and Arms following the order and pattern in Fig. 5a, and complete this Section by connecting a C4

Arm to 45° Hub (1d) on Section 1.

d. Adjust the position of Stay Clip 2 to the middle of the C8 Arm (approx. 4" from one end) and approx. 1” from the

Linear Hub (1c) on Section 1.

NOTE: Do not tighten the screw on Stay Clip 2 until all Arms and Hubs have been connected.

5¼" (4)

7¼" (2)

9¼" (1)

Arm Length Key

IMPORTANT:

Be sure to install all

M2 Set Screws to secure

the Arms to the Hubs,

as shown on page 6.

START

HERE