Installation Sheet

November 20, 2018

8 of 12

Fig. 4a

Fig. 4b

SECTION 1

a. Build this section using the Hubs labeled Section 1 in the Hubs box, and Connecting Arms from the Section 1 box.

b. Start by connecting a C9 Arm to a 45° Hub (1a), and insert into Stay Clip 1 (Fig. 4b), then insert into the Hang Clip and

connect to the Power Feed Hub (1b) as shown below (Fig. 4a). Tighten the Hang Clip approx. 4” from the Power Feed Hub.

c. Connect the Power Feed Hub to the Power Feed and install per the instructions on page 5.

d. Continue by connecting the C4 Arm to the Power Feed Hub (1b), then connect a Linear Hub (1c), a C9 Arm, and Stay Clip 2

approx. 1" from the Linear Hub (Fig. 4a).

e. Complete this Section by connecting Hubs and Arms following the order and pattern in Fig. 4a.

Stay Clip 2

Stay Clip 1

Hang Clip

4¼" (1)

5¼" (1)

7¼" (1)

9¼" (3)

11¼" (3)

Arm Length Key

IMPORTANT:

Be sure to install all

M2 Set Screws to secure

the Arms to the Hubs,

as shown on page 6.

START

HERE