Installation Sheet

November 20, 2018

6 of 12

Small Hex Wrench

Neck

M2 Set Screw

Arm

Hang Clip

Screw

Large Hex Wrench

Stay Clip

Fig. 2a Fig. 2b

Fig. 3a

Fig. 3b

Arm and LED Hub Assembly:

1. Install each Arm into an LED Hub by fully inserting the Arm into a Neck on the Hub (Figs. 2a/2b).

2. After each Arm is connected to the Hub, install the M2 Set Screw into the Neck of the Hub, using the Small Hex Wrench

provided, and tighten until it comes in contact with the plastic cap on the Arm. DO NOT OVERTIGHTEN THE SCREWS.

Arm and Hang Clip Assembly:

1. Install Arm into the Hang Clip (Fig. 3a) by sliding the Arm through the Clip.

2. Once the Arm is in the desired location, tighten the Screw using the Large Hex Wrench provided.

Arm and Stay Clip Assembly:

1. Connect 2 Arms together using the Stay Clip (Fig. 3b) by sliding each Arm through the Clips.

2. Once the Arms are in the desired positions, tighten the Screw using the Large Hex Wrench provided.

COMPONENT INSTALLATION

INSTRUCTIONS D’INSTALLATION