Installation Sheet
November 20, 2018
©2018 SONNEMAN - A Way of Light
5 of 12
REMOTE POWER SUPPLY AND POWER FEED INSTALLATION
Remote Power Supply Installation (Fig. 1a):
1. Shut o power to the Outlet Box.
2. Install the Power Supply in a remote and accessible location
near the xture in accordance with local electrical code.
Make appropriate electrical connections using wire nuts:
a. Connect the Power Supply’s live wire (black) to the live
supply wire.
b. Connect the Power Supply’s neutral wire (white) to the
neutral supply wire.
c. Connect the Power Supply’s positive (+) output wire (red)
to the required length of red wire (not included) to reach
the Outlet Box.
d. Connect the Power Supply’s negative (-) output wire (black)
to the required length of black wire (not included) to reach
the Outlet Box.
Power Feed and Section 1 Installation (Fig. 1b):
NOTE: Do not install the Power Feed until completing all
assembly steps (Section 1-4) and adjusting conguration
height.
3. Install Section 1 (page 8) to the Power Feed by inserting the
end of the Hang Clip Cable into the Cable Gripper until the
Hang Clip is set to the desired height. To shorten the cable,
push the cable up and it will be locked automatically. To
lengthen the cable, lift up on the cable and push up on the
gripper. While keeping the gripper depressed, lower the
cable to the desired height and release the gripper to set.
Reserve excess Cable in the Power Feed.
4. Feed the Cord on the Power Feed Hub through the Bushing
on the Power Feed. Adjust the cord length the remove the
slack, and secure with the Slotted Set Screw using the provided
Screwdriver. Reserve excess Cord in the Power Feed.
5. Attach the Mounting Plate to the Outlet Box using the two (2)
Outlet Box Screws.
6. Make appropriate electrical connections using wire nuts:
a. Connect the positive (red) low voltage wire from the
Power Supply to the red side of the Power Feed Hub Cord.
b. Connect the negative (black) low voltage wire from the
Power Supply to the black side of the Power Feed Hub Cord.
c. Connect the xture’s ground wire (green or uncoated) to the
ground outlet box wire. If no ground is present in outlet box,
connect xture’s ground wire to the Mounting Plate using the
green screw (included).
d. Carefully place the connections in the Outlet Box.
7. Install the Power Feed to the Mounting Plate and secure with
Set Screws using the Medium Hex Wrench provided.
8. Restore power to Outlet Box.
Power Feed
Set Screw
Mounting Plate
Power Feed Hub
Medium
Hex
Wrench
Outlet Box
Screw
Fig. 1b
Fig. 1a
Slotted Set Screw
Cord
Bushing
Hang Clip
Cable
Cable Gripper
(extra cable)
Outlet Box
Remote Power Supply
Screwdriver